Key takeaways
- The Urban Greening Factor (UGF) is a London Plan score that major developments must reach: 0.4 for mainly residential schemes and 0.3 for mainly commercial ones.
- An extensive green roof that meets the GRO Code scores 0.7 and an intensive green roof scores 0.8, so on tight urban sites the roof often does most of the work.
- A lightweight sedum mat that does not meet the GRO Code scores only 0.3, which can be the difference between passing and failing.
Get the green roof specified early, alongside the waterproofing and the structure, and the score usually follows.
If you are planning a major development in London, the Urban Greening Factor will appear in your planning conditions. It is one of the main reasons green roofs have gone from an architectural extra to a standard part of London buildings, and it is often the single biggest influence on what goes on the roof.
This guide explains what the Urban Greening Factor is, how the score is worked out, what different green roofs score, and the common specification mistake that can cost a scheme its target. It is written for developers, architects, local authorities and housing providers planning new buildings or major refurbishments.
What is the Urban Greening Factor?
The Urban Greening Factor is a tool in the London Plan 2021 (Policy G5) that measures how much greening a development provides compared with its site area. London boroughs apply it to major development proposals, and the London Plan sets interim target scores of:
- 0.4 for developments that are mainly residential
- 0.3 for mainly commercial development (excluding general industrial and storage uses)
Some boroughs set their own targets in their local plans, so always check the policy for the borough where the site sits.
How the score is calculated
Every surface on the site is given a factor between 0 and 1, depending on how much environmental value it provides. You multiply each surface’s area by its factor, add the results together, and divide by the total site area. The scores most relevant to roofs and landscaping are:
- Intensive green roof (at least 150mm of substrate): 0.8
- Extensive green roof meeting the GRO Code 2014 (at least 80mm of substrate, or 60mm beneath a vegetation blanket): 0.7
- Flower rich perennial planting and rain gardens: 0.7
- Green wall: 0.6
- Amenity grassland (regularly mown lawn): 0.4
- Extensive green roof with a sedum mat or lightweight system not meeting the GRO Code: 0.3
- Permeable paving: 0.1
- Sealed surfaces (concrete, asphalt, a standard waterproofed roof): 0
Semi natural vegetation and wetland score the full 1.0, but on a dense urban site there is rarely room for much of either.
Why green roofs do so much of the work
On most London sites the building covers a large share of the plot, and what is left at ground level is taken up by access roads, parking, bin stores and paths. A standard flat roof scores nothing. Turn that same roof into a compliant extensive green roof and every square metre scores 0.7, almost as much as planting on open ground.
That is why green roofs appear in so many London planning conditions. They are usually the most space efficient way to reach the target without giving up floor space or ground level parking.
A worked example
Take a 2,000m² residential site. The building’s flat roof covers 1,000m², and the ground level has 400m² of lawn, 100m² of permeable paving and 500m² of tarmac and paths.
- With a standard roof: lawn 400 × 0.4 = 160, paving 100 × 0.1 = 10, roof and tarmac 0. Total 170 ÷ 2,000 = 0.085. Well short of 0.4.
- With 900m² of GRO Code extensive green roof (leaving 100m² for plant, access and maintenance zones): 900 × 0.7 = 630, plus 170 from the ground. Total 800 ÷ 2,000 = 0.40. Target met.
- With 900m² of lightweight sedum mat that does not meet the GRO Code: 900 × 0.3 = 270, plus 170. Total 440 ÷ 2,000 = 0.22. Target missed.
Same roof, same area, very different result. The difference is entirely down to the specification.
The 0.3 trap: why the specification matters
Thin sedum mats are light and cheap, which makes them tempting, especially on existing buildings with limited structural capacity. But unless the system meets the GRO Code (the Green Roof Organisation’s code of best practice), it scores 0.3 rather than 0.7. On a scheme relying on the roof to reach its target, that can mean a failed planning condition, a redesign, or extra greening squeezed in elsewhere at higher cost.
The practical lesson is to agree the green roof specification early, with the substrate depth, planting type and drainage layers written into the design, rather than leaving it to be value engineered later.
Designing a roof that scores well
A green roof is only as good as the roof underneath it. When we specify a green roof for a UGF target, we look at four things together:
- Structure. A deeper substrate scores more but weighs more. The structural engineer needs the saturated load early, before the frame is designed.
- Waterproofing. The green roof sits on the waterproofing for decades, so it needs a root resistant system installed as one build up. We install green roofs over Bauder and Polyroof waterproofing for that reason.
- Insulation. Most new flat roofs are designed as warm roofs to meet Part L, and the green roof goes on top. Our post on warm roof systems explains the build up.
- Other roof uses. Plant, access routes and solar PV all compete for space. Solar and green roofs can share the same roof, as our green roof and solar PV comparison explains, but the layout needs planning from the start.
A biodiverse roof with varied substrate and native planting can also help a scheme meet its biodiversity net gain requirement, so the same roof can work for both policies.
What about existing buildings?
The Urban Greening Factor applies to new major development, but the same logic is useful on existing buildings. If a flat roof is due for replacement anyway, that is the cheapest time to add a green roof: the old roof comes off, the structure is checked, and the new waterproofing and green roof go down together. If the roof is still sound, a flat roof overlay may be the better first step. Our page on green roofs in Croydon shows how this works in our home borough.
Why it starts with a survey
Whether you are designing a new scheme or adding greening to an existing building, the first question is what the roof can carry and what the target needs. Our roof surveys check the structure and the existing waterproofing, and our green roof installation team can then specify a system that reaches your score and lasts.
Planning a green roof to meet an Urban Greening Factor target? DL Jones has installed flat roofs across London and the South East since 1987. Call 020 8657 0734 or book a free survey.
Frequently Asked Questions
What is a good Urban Greening Factor score?
The London Plan sets interim targets of 0.4 for mainly residential developments and 0.3 for mainly commercial developments. Some boroughs set their own targets in their local plans, so check the policy for your site’s borough.
Does a sedum roof count towards the Urban Greening Factor?
Yes, but how much depends on the system. An extensive green roof that meets the GRO Code 2014, with at least 80mm of substrate or 60mm beneath a vegetation blanket, scores 0.7. A lightweight sedum mat that does not meet the GRO Code scores only 0.3.
Does the Urban Greening Factor apply to every development?
No. London boroughs apply it to major development proposals. Smaller schemes are not normally required to calculate a score, although greening is still encouraged and some boroughs ask for more.
Can a green roof and solar panels count on the same roof?
Yes, they can share a roof. The green roof area counts at its own factor, and panels can sit on raised frames above the planting. Agree with the planning officer early how the area under the panels will be measured.
Is the Urban Greening Factor the same as biodiversity net gain?
No. The Urban Greening Factor is a London Plan measure of greening on a site. Biodiversity net gain is a national requirement under the Environment Act 2021 to improve habitat value by at least 10%. A well designed biodiverse green roof can help with both.




